明仕彩票平台

压降型PWM外文翻译--基于降压型PWM开关电源的建模、仿真和减少传导电磁干扰压降型PWM外文翻译--基于降压型PWM开关电源的建模、仿真和减少传导电磁干扰

收藏 分享

资源预览需要最新版本的Flash Player支持。
您尚未安装或版本过低,建议您

中文 1790字 Modeling, Simulation, and Reduction of Conducted Electromagnetic Interference Due to a PWM Buck Type Switching Power Supply I 基于降压型 PWM 开关电源的建模、仿真和减少传导电磁干扰 I I. INTRODUCTION FAST semiconductors make it possible to have high speed and high frequency switching in power electronics 1 . High speed switching causes weight and volume reduction of equipment, but some unwanted effects such as radio frequency interference appeared 2 . Compliance with electromagnetic compatibility (EMC) regulations is necessary for producers to present their products to the markets. It is important to take EMC aspects already in design phase 3 . Modeling and simulation is the most effective tool to analyze EMC consideration before developing the products. A lot of the previous studies concerned the low frequency analysis of power electronics components 4 5 . Different types of power electronics converters are capable to be considered as source of EMI. They could propagate the EMI in both radiated and conducted forms. Line Impedance Stabilization Network (LISN) is required for measurement and calculation of conducted interference level 6 . Interference spectrum at the output of LISN is introduced as the EMC evaluation criterion 7 8 . National or international regulations are the references for the evaluation of equipment in point of view of EMC 7 8 . II. SOURCE, PATH AND VICTIM OF EMI Undesired voltage or current is called interference and their cause is called interference source. In this paper a high-speed switching power supply is the source of interference. Interference propagated by radiation in area around of an interference source or by conduction through common cabling or wiring connections. In this study conducted emission is considered only. Equipment such as computers, receivers, amplifiers, industrial controllers, etc that are exposed to interference corruption are called victims. The common connections of elements, source lines and cabling provide paths for conducted noise or interference. Electromagnetic conducted interference has two components as differential mode and common mode 9 . A. Differential mode conducted interference This mode is related to the noise that is imposed between different lines of a test circuit by a noise source. Related current path is shown in Fig. 1 9 . The interference source, path impedances, differential mode current and load impedance are also shown in Fig. 1. B. Common mode conducted interference Common mode noise or interference could appear and impose between the lines, cables or connections and common ground. Any leakage current between load and common ground could be modeled by interference voltage source. Fig. 2 demonstrates the common mode interference source, common mode currents Icm1 and Icm2 and the related current paths9 . The power electronics converters perform as noise source between lines of the supply network. In this study differential mode of conducted interference is particularly important and discussion will be continued considering this mode only. III. ELECTROMAGNETIC COMPATIBILITY REGULATIONS Application of electrical equipment especially static power electronic converters in different equipment is increasing more and more. As mentioned before, power electronics converters are considered as an important source of electromagnetic interference and have corrupting effects on the electric networks 2 . High level of pollution resulting from various disturbances reduces the quality of power in electric networks. On the other side some residential, commercial and especially medical consumers are so sensitive to power system disturbances including voltage and frequency variations. The best solution to reduce corruption and improve power quality is complying national or international EMC regulations. CISPR, IEC, FCC and VDE are among the most famous organizations from Europe, USA and Germany who are responsible for determining and publishing the most important EMC regulations. IEC and VDE requirement and limitations on conducted emission are
编号:201407241401163185    类型:共享资源    大小:244。00KB    格式:DOC    上传时间:2017-04-14
  
100
金币
关 键 词:
压降型 pwm 外文 翻译 基于 降压 开关电源 建模 仿真 以及 减少 传导 电磁 干扰
资源描述:
中文 1790字 Modeling, Simulation, and Reduction of Conducted Electromagnetic Interference Due to a PWM Buck Type Switching Power Supply I 基于降压型 PWM 开关电源的建模、仿真和减少传导电磁干扰 I I. INTRODUCTION FAST semiconductors make it possible to have high speed and high frequency switching in power electronics 1 . High speed switching causes weight and volume reduction of equipment, but some unwanted effects such as radio frequency interference appeared 2 . Compliance with electromagnetic compatibility (EMC) regulations is necessary for producers to present their products to the markets. It is important to take EMC aspects already in design phase 3 . Modeling and simulation is the most effective tool to analyze EMC consideration before developing the products. A lot of the previous studies concerned the low frequency analysis of power electronics components 4 5 . Different types of power electronics converters are capable to be considered as source of EMI. They could propagate the EMI in both radiated and conducted forms. Line Impedance Stabilization Network (LISN) is required for measurement and calculation of conducted interference level 6 . Interference spectrum at the output of LISN is introduced as the EMC evaluation criterion 7 8 . National or international regulations are the references for the evaluation of equipment in point of view of EMC 7 8 . II. SOURCE, PATH AND VICTIM OF EMI Undesired voltage or current is called interference and their cause is called interference source. In this paper a high-speed switching power supply is the source of interference. Interference propagated by radiation in area around of an interference source or by conduction through common cabling or wiring connections. In this study conducted emission is considered only. Equipment such as computers, receivers, amplifiers, industrial controllers, etc that are exposed to interference corruption are called victims. The common connections of elements, source lines and cabling provide paths for conducted noise or interference. Electromagnetic conducted interference has two components as differential mode and common mode 9 . A. Differential mode conducted interference This mode is related to the noise that is imposed between different lines of a test circuit by a noise source. Related current path is shown in Fig. 1 9 . The interference source, path impedances, differential mode current and load impedance are also shown in Fig. 1. B. Common mode conducted interference Common mode noise or interference could appear and impose between the lines, cables or connections and common ground. Any leakage current between load and common ground could be modeled by interference voltage source. Fig. 2 demonstrates the common mode interference source, common mode currents Icm1 and Icm2 and the related current paths9 . The power electronics converters perform as noise source between lines of the supply network. In this study differential mode of conducted interference is particularly important and discussion will be continued considering this mode only. III. ELECTROMAGNETIC COMPATIBILITY REGULATIONS Application of electrical equipment especially static power electronic converters in different equipment is increasing more and more. As mentioned before, power electronics converters are considered as an important source of electromagnetic interference and have corrupting effects on the electric networks 2 . High level of pollution resulting from various disturbances reduces the quality of power in electric networks. On the other side some residential, commercial and especially medical consumers are so sensitive to power system disturbances including voltage and frequency variations. The best solution to reduce corruption and improve power quality is complying national or international EMC regulations. CISPR, IEC, FCC and VDE are among the most famous organizations from Europe, USA and Germany who are responsible for determining and publishing the most important EMC regulations. IEC and VDE requirement and limitations on conducted emission are
展开阅读全文
  毕设资料网所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。
0条评论

还可以输入200字符

暂无评论,赶快抢占沙发吧。

关于本文
本文标题:压降型PWM外文翻译--基于降压型PWM开关电源的建模、仿真和减少传导电磁干扰
链接地址:http://www.indiasbook.com/p-1390803.html

当前资源信息

4.0
 
(2人评价)
浏览:167次
泛舟上传于2017-04-14

相关资源

  • 【精品文档】453关于计算机专业软件框架架构设计优化有关的外文文献翻译成品:软件体系结构优化方法:系统性文献综述(中英文双语对照)【精品文档】453关于计算机专业软件框架架构设计优化有关的外文文献翻译成品:软件体系结构优化方法:系统性文献综述(中英文双语对照)
  • 【精品文档】459关于社会进步与生态环境土地污染绿色低碳可持续增长有关的外文文献翻译成品:经济发展与环境保护:生态经济学的视角(中英文双语对照)【精品文档】459关于社会进步与生态环境土地污染绿色低碳可持续增长有关的外文文献翻译成品:经济发展与环境保护:生态经济学的视角(中英文双语对照)
  • 【精品文档】500关于计算机专业软件病毒漏洞安全攻击优化管理设计防护有关的外文文献翻译成品:开源系统的软件安全性(中英文双语对照)【精品文档】500关于计算机专业软件病毒漏洞安全攻击优化管理设计防护有关的外文文献翻译成品:开源系统的软件安全性(中英文双语对照)
  • 【精品文档】460关于我国营改增VAT增值税营业税发展现状对策改革战略有关的外文文献翻译成品:中国增值税改革的发展策略(中英文双语对照)【精品文档】460关于我国营改增VAT增值税营业税发展现状对策改革战略有关的外文文献翻译成品:中国增值税改革的发展策略(中英文双语对照)
  • 【精品文档】498关于房地产公司互联网营销策略战略有关的外文文献翻译成品:房地产企业网络营销研究(中英文双语对照)【精品文档】498关于房地产公司互联网营销策略战略有关的外文文献翻译成品:房地产企业网络营销研究(中英文双语对照)
  • 【精品文档】496关于电气工程自动化编程控制有关的外文文献翻译成品:基于LabView的双通道示波器设计和基本电路仿真(中英文双语对照)明仕彩票平台【精品文档】496关于电气工程自动化编程控制有关的外文文献翻译成品:基于LabView的双通道示波器设计和基本电路仿真(中英文双语对照)
  • 【精品文档】494关于学院生态景观规划有关的外文文献翻译成品:卡斯塔莫努大学校园天然植物物种在景观设计中的利用(中英文双语对照)【精品文档】494关于学院生态景观规划有关的外文文献翻译成品:卡斯塔莫努大学校园天然植物物种在景观设计中的利用(中英文双语对照)
  • 【精品文档】468关于智能街灯照明系统设计有关 的外文文献翻译成品:基于ZigBee的智能路灯系统(中英文双语对照)【精品文档】468关于智能街灯照明系统设计有关 的外文文献翻译成品:基于ZigBee的智能路灯系统(中英文双语对照)
  • 【精品文档】493关于道路标记标志跟踪监测有关的外文文献翻译成品:通过图像处理算法改进交通信号检测和分类(中英文双语对照)【精品文档】493关于道路标记标志跟踪监测有关的外文文献翻译成品:通过图像处理算法改进交通信号检测和分类(中英文双语对照)
  • 【精品文档】497关于火车铁路铁轨高铁噪音旅客旅行舒服度有关的外文文献翻译成品:高速列车上的乘客舒适度:隧道噪声对压力变化主观评估的影响(中英文双语对照)【精品文档】497关于火车铁路铁轨高铁噪音旅客旅行舒服度有关的外文文献翻译成品:高速列车上的乘客舒适度:隧道噪声对压力变化主观评估的影响(中英文双语对照)
  • 【精品文档】491关于酒店饭店饭馆餐馆餐饮室内空间创造性设计有关的外文文献翻译成品:餐厅空间规划中的专业创意概念(中英文双语对照)【精品文档】491关于酒店饭店饭馆餐馆餐饮室内空间创造性设计有关的外文文献翻译成品:餐厅空间规划中的专业创意概念(中英文双语对照)
  • 精品推荐

    简历广告
    关于我们 - 网站声明 - 网站地图 - 资源地图 - 友情链接 - - 联系我们
    本站所有资料均属于原创者所有,仅提供参考和学习交流之用,请勿用做其他用途,转载必究!如有侵犯您的权利请联系本站,一经查实我们会立即删除相关内容!
    copyright@ 2008-2025 毕设资料网版权所有
    网站备案号:

    举报邮箱:540560583@qq.com
    上海11选5 博赢彩票app 皇浦彩票官网 赖子棋牌 一起玩彩票app 099彩票注册 必威彩票注册 云海彩票投注 博虎彩票app 秒速赛车登陆